IPv6 Enabled

[dimiden]

Now, we can use IPv6 addresses in OME!
To use IPv6, you must use the source of master branch and you need to set the IPv6 addresses to Server.xml as follows:

<Server>
    <IP>*</IP> <!-- As you know, this means that all Providers/Publishers are bound to all IPv4 interfaces -->
    <IP>::</IP> <!-- This means that all Providers/Publishers are bound to all IPv6 interfaces -->
    ...
</Server>

This will enable IPv6 on most Providers/Publishers. If you are using WebRTC Providers/Publishers, it's required additional ICE candidate settings like below:

<Server>
    <Bind>
        <Providers> <!-- You can use this settings by applying the same to Publisher -->
            <WebRTC>
                <IceCandidates>
                    <TcpRelay>*:3478</TcpRelay> <!-- TURN server will be listen on 0.0.0.0:3478 -->
                    <TcpRelay>[::]:3478</TcpRelay> <!-- TURN server will be listen on [::0]:3478 -->

                    <IceCandidate>*:10000-10001/udp</IceCandidate> <!-- Gather ICE Candidates for IPv4 addresses -->
                    <IceCandidate>[::]:10000-10001/udp</IceCandidate> <!-- Gather ICE Candidates for IPv6 addresses -->
                ...

This is all the setup to use IPv6!

If set as above, you can send a RTMP stream or call the API of OME using an IPv6 address, and you can also specify an IPv6 address for AdmissionWebhooks/ControlServerUrl.

Our development environment has many restrictions on using IPv6, so we have not been able to test IPv6 in various scenarios.
We need help to support IPv6 more perfectly!