README.md

Manta E3EZ V1.0 + CB1 V2.2 + Hermit Crab V2.0 CAN Bus Setup for Ender 3 Pro

Introduction

I have prepared this document to outline the steps required to set up the CAN (Control Area Network) Bus for Manta E3EZ V1.0, CB1 V2.2, and Hermit Crab V2.0 CAN Version.

I have used the following boards and components:

• BIGTREETECH Manta E3EZ V1.0 Board
• BIGTREETECH CB1 V2.2
• BIQU Hermit Crab V2.0 - CAN Version
• Micro SD card
• Micro SD card reader
• Micro USB cable
• USB-C cable

Table of Contents

1. CB1 to E3EZ Installation and Mainsail Setup
2. CAN Bus Setup on CB1
3. Connect Hermit Crab V2.0 to E3EZ

Sources

• BIGTREETECH Manta E3EZ V1.0 Board - User Manual
• BIGTREETECH CB1 V2.2 - User Manual
• Biqu Hermit Crab V2.0 CAN Version - User Manual
• Arksine’s “Katapult” Repository
• Fredrik Åsberg’s “BTT Manta M8P v1.1 + BTT EBB 2209 Canbus setup” Repository
• Hobbyist Notes’ “Klipper CAN BUS Guide - BIGTREETECH E3EZ with Hermit Crab 2” Video