BE Hydroponics

Set your house ambience with respect to the ambient temperature using a temperature sensor and WS281B Addressable LEDs in 5 steps

Pre-requisites

• Hardware

  • Arduino Uno or any other equivalent board
  • NodeMCU ESP8266
  • 5v Power supply
  • 3 Male-to-female Jumper Cables
  • DHT11 or newer temperature sensor
  • Breadboard (Optional)

• Software

  • Arduino IDE
  • Library : FastLED (not by AdaFruit) & Unified Sensor by AdaFruit howTo & DHT

Usage

Step 1 : Open main.ino on your Arduino IDE
Step 2 : Install FastLED & Unified Sensors by AdaFruit
Step 3 : Enter the number of LEDs on your strip on the 4th line (Change data pins according to your prefrence if needed)
Step 4 : Select the right Com port via Tools
Step 5 : Make the right connections (Check figure below)
Step 5 : Hit Upload

Note : Disconnect the power supply jumper cable to LED & Sensor to avoid any unwanted issues