This section might not have any sense for you. I just keep it for tracking what I am missing.
-
Place the reflecting aluminum under the roof plates
- 4 x 44cm x 138cm
- 1 x 20cm x 138cm
-
Test machines on lipo
- Ultimaker 2
-
Clean Car Interior
-
Clean glass in+out
-
Use AC spray cleaner
-
Change habitable filter
-
Service Car
-
Put varnish on the supports, table and plate
-
Mark support drills on the plate
-
Mark tension drills on the plate across XY
-
Place putty on wood
-
Buy/get ultimaker connector (Kycon 4 pin)
-
Build control panel for the rear door (to control the equipment)
-
Draw and upload the trunk wood design
-
Fix rear right lock door
-
Print cam cleats and fiddle blocks
-
Yakima roof tent