Tree Configuration not saving actions #14
Replies: 2 comments
-
I cannot reproduce it, so there may be some misunderstanding. Here you entered IP's raise 30 action, which follows OOP's bet 10 action. The "Added line" also shows the "Bet 10 - Raise 30" line. When you click "Save Edit", this line should be saved. Then, when you return to the tree edit screen again, it is okay to see image 1. because the tree edit screen does not remember the state (i.e., the last position viewed). The problem is whether the "Bet 10 - Raise 30" line is saved or not. To check this, you should click on OOP's bet 10 action and see if there is IP's raise 30 action. |
Beta Was this translation helpful? Give feedback.
-
I think I figured it out. I wasn't clicking on the action in the Results. When I click on the action in the results, it shows the IP possible actions, which were hidden before selecting OOP action. |
Beta Was this translation helpful? Give feedback.
-
When I try to set up a tree for the solver, I add some actions by clicking "Preview and Edit Tree" and then entering actions. Then, I click 'Save edit', and this brings me back to the main Tree Configuration screen. However, when I try to preview the tree again, those actions I entered are gone and only the first flop action remains.
Maybe I'm just not doing this right, but is there some kind of manual I can consult?
1 - start of tree
2 - I enter actions
3 - I save the new actions
Then it brings me back to the main tree configuration. But if I click Preview and Edit tree again, it shows image 1. The actions in image 2 are gone.
What am I doing wrong?
Beta Was this translation helpful? Give feedback.
All reactions