Reset behaviour on Sequence5

[aureal-toptics]

Hello - Sequence 5 jumps to the 2nd step when you set it a reset trigger while also clocking it.

I gather this could be because with these signals it gets reset while simultaneously advancing to the next step. But this feels buggy and makes the reset difficult if not possible to use normally.

Is a fix possible?

[benirose]

Yes, I've been meaning to get around to this, there's a fix in an issue on the main Hemispheres repo, I'll try to get it in to the 1.2 release!

[aureal-toptics]

That would be awesome, thank you. I use that app a lot, this will make it much better!

[benirose]

I was able to address the behavior of resetting while being clocked fairly easily, however there's still an issue where resetting while stopped causes the first clock it receives to advance to step 2. This kind of makes sense but I feel like is also wrong, but will require changing out some of the underlying code to fix. I'll see if I can fix that behavior in this upcoming release, but at minimum the reset while clocking behavior will be addressed!

[benirose]

I took a look at my Korg SQ-1 and when reset it "repeats" the first step one first clock signal. I think this is the correct behavior and would like to fix this.

[aureal-toptics]

Thanks very much for looking into it 😊

[benirose]

I fixed the behavior of reset while being clocked in 1.2. I’ll open a new ticket for fixing reset behavior in all of the sequencers while not clocked since it seems to be the behavior across all of them.