mazda-firmware-changelogs

Version 70.00.021A

• Pause when muted in MZD Connect.

Version 70.00.000A

• Carplay / Andriod Auto Support added

Version 59.00.546A

• Rear view monitor brightness settings have been disabled for compliance requirement.

Version 59.00.545A

Changes / improvements in version 59.00.545A:

The following symptoms can be fixed by updating the software to the newest version (currently 59.000.545A). Improvements and fixes of malfunctions depend on the current software version (software) installed on the car.

• [Only version 59.00.544, except 2017-2018 Mazda3 (manufactured in Mexico)] When using the memory function for adjusting the seat position and the active driver display, an audible signal may not be output after automatic adjustment is completed. The display settings for navigation system prompts on the active driver display may not be saved for the function of storing seat position settings and the active driver display.

Changelog Source - ASH8 Mazda3Revolution

Version 59.00.544A

The following symptoms can be fixed by updating the software to the newest version.

• When playing back from an audio device connected via Bluetooth, an illustration of the album is not available even if it is found in the Gracenote® database stored in the CMU memory.

• On some narrower roads, the speed limit on the navigation system screen is not displayed.

• If you select one of the stations stored in the selected radio, the radio can be tuned to receive another radio station.

• Devices with Android 8.0 are not recognized when connected via USB.

• [For vehicles with an active driver display only], the Road Recognition System (TSR) after resetting to the factory settings (Factory Reset) does not store the time-of-warning setting for the allowed speed at which an alert should be issued.

• Incoming calls, the display shows the wrong name of the caller.

• Invalid units of measurement may appear on the fuel economy monitoring function screen.

• The display of the mobile phone may flicker when it is connected via USB.

• The Traffic Signal Recognition System (TSR) does not give a warning corresponding to the selected setting for the speed limit alert. It can warn of a speed of 6 or 10 mph greater than the set speed.

• [Version 59.00.540 only] If you select a destination, an "House Number not found" pop-up message may appear in the address, even if you can actually select the address.

• [Version 59.00.540 only] If you try to enter the address of a new destination, another house number may appear for it, although the correct house number is actually selected.

• [Version 59.00.540 only] If you try to enter the address of a new destination, some house numbers may not appear in the list for selection.

• [Portuguese] Information on lanes / streets / bends may not be fully displayed on the display.

• [Polish] Due to incorrect translation, the home address is not deleted from the favorites list.

Version 59.00.540A

• When Pandora® is connecting to the vehicle, the screen color and the logo have been changed.

• Warning Guidance “i-ELOOP Charging” in the center display has been removed.

• i-Pod nano 5th gen will not play.

• [Only vehicles equipped with the Forward Sensing Camera] Warning Guidance message to clear foggy windshiled is shown even if it is not foggy. (The message has been changed.)

• Fuel Economy Monitor may draw bars twice a minute instead of once a minute.

• [Canada and Mexico] Some vehicles in Fixed engine oil maintenance mode may experience that the remaining mileage does not decrease.

• [USA] Some vehicles in Flexible engine oil maintenance mode may experience that the remaining mileage returns to 620 miles (1000 km) from less than 620 miles (1000 km).

• [CX-9 with Active Driving Display] Speed limit display in the MAZDA CONNECT screen has been disabled.

• The setting tab works as if the ignition is in ACC instead of ON.

• [Swedish] Wrong translation for the strip follower system. "Alarttiming" was changed to "Varningstiming".

• [German] Invalid translation of automatic door locking settings

Version 59.00.504A

• Unknown

Version 59.00.502A

Note: The system performance has been improved as follows:

• USB Auto run vulnerability descibed in Forbes article

• System stability and response of the CMU.

  • Mininize unexpected reboots and blank or frozen screens.
  • Faster start up.
  • Faster operational response.

• Connectivity and stabliity for BT devices.

  • Improved stability of connection.
  • Reduced connection error with internet radio applications.

• Stability for USB audio device.

  • Faster response when hundreds of songs are being read out of USB audio devices.

• Connection stability and functionality with iPhone.

  • Device name can be displayed not only via BT connection but also via USB connection.
  • Improved stablity when iPhone is connected via both BT and USB.

Changelog Source - Version 55 - 59 Changelog Source 2

Version 59.00.441A

• With ignition ON, "SCBS Unavailable" or "LDWS Unavailable" message may be displayed due to false error detection by CMU, but the systems actually do work. No DTC is stored in memory and no message appears in the multi-information display. (2014-2015 Mazda3 equipped with SCBS, LDWS and CMU ver. 59.00.441/443/445)

Version 59.00.330 (Download not available)

• DTC U0100:00 [CONNECTIVITY MASTER UNIT] (communication error with PCM) is stored in memory.

• Warning guidances are displayed both for LDWS and HBC (CX-3 with LDWS and without HBC only).

• Improper OFF selection in the Setting Interval menu under Oil Change (CX-9 only).

• Resetting with "Fixed" data will not reset "Flexible" data. (CX-9 only).

Version 55.00.760A

• Naviation or other screen freeze or reboot.

• Issues with Pandora Radio.

• USB device fails to start playing, resume or display music information. BT audio device fails when starting to play, resume or connect.

• Paired BT device will not connect. Removing the paired BT device from the vehicle (but not the vehicle from the phone) results in an endless "Deleting" message.

Version 55.00.753A

From 59.00.502A - previous versions section which may or may not be this version specifically

• Some street names in Canada are not displayed.

• Navigation does not allow to set certain cities as destination.

• Navigation does not announce voice guidance for street names.

• Navigation turns to a black screen, but the menu bar remains.

• Turn -by-turn navigation guidance does not display on on the active driving display (for vehicles with 55.00.750).

• Every time the navigation is turned on, the vehicle position starts from the location (dealer) where the CMU was updated from version 55.00.650 to 55.00.750.

• Navigation or other screen turn black, freeze or reboot.

• System does not recognize USB/SD card.

• Some menu of music source selection is grayed out.

• When using the call button on the cell phone to make a call, the call sound is short.

• Favorites disappear.

• Vehicle current position is not accurate enough.

• Rear view monitor does not show up on screen.

• Text information of HD radio is not displayed when switching music source.

• When asking for currect location with voice command "Where am I?", the system responds with "Your location is comma."

• Contact information cannot be loaded correctly from phones other then iPhone.

Version 55

This firmware update contains all improvements in prior versions and also includes:

• Users with mixed entertainment favorites (FM/AM/XM) can now switch between their favorites in the same order that they’re listed on the Mazda Connect display using the steering wheel control buttons.

• Bluetooth audio metadata (artist / song / album name) now refreshes in the background whenever the Mazda Connect display isn’t showing the Bluetooth audio screen.

• The speed and performance of HD radio text and images has been improved.

• The loading speed of HD traffic maps has been improved.

• In addition to using the volume controls to adjust the navigation guidance volume levels, navigation guidance volume can now be adjusted at any time using the navigation guidance settings option within the navigation settings menu- even while the vehicle is in motion.

• Increased performance and consistency in phonebook contacts download.

• Faster availability of voice recognition for calling phonebook contacts.

• The system will now inform you if it is too soon to use voice recognition when calling contacts.

• Increased navigation stability and bug fixes.

• Navigation voice recognition improvements (e.g. “airport”, “where am i?”).

• Enhanced Bluetooth audio sound quality. Audio no longer has audible stutter or skip when changing tracks.

• Reverse back-up camera display speed, performance, and bug fix enhancements.

• Bug fix for erroneous “Does not recognize” USB and/or SD Card messages.

• USB device recognition performance improved and will recognize device is inserted more accurately.

• Steering wheel volume control speed and performance enhancements.

• Pandora, Aha, Stitcher performance and bug fix enhancements.

• iPod/iPhone USB media cataloging speed and performance enhancements.

Version 33

This firmware update contains all improvements in Version 31 and prior and also includes:

• Restores audible notification when the speed limit is exceeded on the navigation map screen.

• The vehicle icon on the navigation map performance and accuracy improved.

• Navigation display graphic improvements and bug fixes.

• Album art is now displayed when an iPhone or iPod is connected via USB.

Version 31

This firmware update contains all improvements in Version 30 and prior and also includes:

• Clock display performance improvements while acquiring GPS reception.

• USB device performance and stability increased.

• Navigation guidance prompts can now be fully muted by turning the volume knob to zero while the guidance prompt is playing or in navigation guidance settings.

Version 30

This firmware update contains all improvements in Version 29 and prior and also includes:

• System memory for settings, favorites, paired devices, and history improved to ensure retention.

• Improved voice recognition performance for calling functions in French.

Version 29

This firmware update contains all improvements in Version 28 and also includes:

• Navigation route guidance improvements and bug fixes when paired to iPhone 4s.

• Added support for voice recognition when importing contacts with special characters (e.g., $, #, etc.) in the name (e.g., “#MOM” or “$AM”).

• Music volume bar is no longer displayed when the navigation system is providing guidance.

• MUTE control button now completely eliminates any audible sounds.

Version 28

This firmware update contains the following improvements:

• Improved graphics and design on Radio screen.

• Bug fixes and improved performance and operation of commander.

• Bug fixes and performance improvements when navigating to an address by selecting an address within a phonebook contact.

Mazda is continuously working to make further improvements to the MAZDA CONNECT™ system software, and may issue further software updates to improve system operation and performance.

NOTE: Map updates are separate to system updates. Click here for map updates.

Changelogs Source - Version 28 to 55