feat(uart): [IDF 5.3] fixes HardwareSerial::updateBaudRate() using a …

…baud rate higher 230400 - checks UART Clock Source (#10643)

* fix(uart): fixes issue with update baudrate higher than 250000

* ci(pre-commit): Apply automatic fixes

---------

Co-authored-by: pre-commit-ci-lite[bot] <117423508+pre-commit-ci-lite[bot]@users.noreply.github.com>

cores/esp32/esp32-hal-uart.c

@@ -33,7 +33,8 @@
 #include "hal/gpio_hal.h"
 #include "esp_rom_gpio.h"
 
-static int s_uart_debug_nr = 0;  // UART number for debug output
+static int s_uart_debug_nr = 0;         // UART number for debug output
+#define REF_TICK_BAUDRATE_LIMIT 250000  // this is maximum UART badrate using REF_TICK as clock
 
 struct uart_struct_t {
 
@@ -522,7 +523,7 @@ uart_t *uartBegin(
 #if SOC_UART_SUPPORT_XTAL_CLK
   uart_config.source_clk = UART_SCLK_XTAL;  // valid for C2, S3, C3, C6, H2 and P4
 #elif SOC_UART_SUPPORT_REF_TICK
-  if (baudrate <= 250000) {
+  if (baudrate <= REF_TICK_BAUDRATE_LIMIT) {
     uart_config.source_clk = UART_SCLK_REF_TICK;  // valid for ESP32, S2 - MAX supported baud rate is 250 Kbps
   } else {
     uart_config.source_clk = UART_SCLK_APB;  // baudrate may change with the APB Frequency!
@@ -804,6 +805,10 @@ void uartSetBaudRate(uart_t *uart, uint32_t baud_rate) {
     return;
   }
   UART_MUTEX_LOCK();
+#if !SOC_UART_SUPPORT_XTAL_CLK
+  soc_module_clk_t newClkSrc = baud_rate <= REF_TICK_BAUDRATE_LIMIT ? SOC_MOD_CLK_REF_TICK : SOC_MOD_CLK_APB;
+  uart_ll_set_sclk(UART_LL_GET_HW(uart->num), newClkSrc);
+#endif
   if (uart_set_baudrate(uart->num, baud_rate) == ESP_OK) {
     uart->_baudrate = baud_rate;
   } else {