This is a design of a dual-layer capacitor, meaning that when this design is fabricated on a two-layer printed circuit board (PCB), there will be four capacitor plates (two per layer) creating a dielectric field between the traces within a single layer and between the traces across layers.
In this design, plate wires can be created with varying trace widths, gaps between traces, and overall size of the board. As a result, this parametric design could theoretically be used for capacitors of any manufacturable size (from microscopic on up).
This shows the various layers on a 100mm x 100mm PCB:
In this section, we will document emperically-measured capacitances as they become available.
Capacitor 1 uses a 0.6mm PCB with 0.6mm traces and measures 1650pF.
Capacitor 2 uses a 0.6mm PCB with 0.15mm traces and measures 2527pF.
Enjoy!
Copyright 2019 Glenn M. Lewis. All Rights Reserved.
Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except in compliance with the License. You may obtain a copy of the License at
http://www.apache.org/licenses/LICENSE-2.0
Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.