Tested configuration for Annke CZ400 PoE LAN camera

[inet-cologne]

Manufacturer/Model:

Annke CZ400
PoE LAN Cam (RTSP, ONVIF)
Homebridge Config:

                {
                    "disable": false,
                    "name": "Cam-01",
                    "manufacturer": "Annke",
                    "model": "CZ400",
                    "serialNumber": "1234567890",
                    "motion": true,
                    "motionTimeout": 15,
                    "unbridge": true,
                    "hsv": true,
                    "prebuffering": true,
                    "prebufferLength": 4,
                    "hksvConfig": {
                        "source": "-i rtsp://user:password@192.168.1.123:554/H264/ch1/main/av_stream"
                    },
                    "videoConfig": {
                        "source": "-i rtsp://user:password@192.168.1.123:554/H264/ch1/main/av_stream",
                        "subSource": "-i rtsp://user:password@192.168.1.123:554/H264/ch1/sub/av_stream",
                        "stillImageSource": "-i rtsp://user:password@192.168.1.123:554/H264/ch1/sub/av_stream",
                        "maxStreams": 2,
                        "vcodec": "copy",
                        "acodec": "libfdk_aac",
                        "audio": false,
                        "debug": false
                    },
                    "smtp": {
                        "email": "Cam-01"
                    },
                    "videoanalysis": {
                        "active": true
                    },
                    "mqtt": {}
                }

Additional Information:

some important settings in the camera setup (not Homebridge) through its web interface:

Stream type: Main stream
Video type: Video-stream
Resolution: 2560x1400
Bit rate type: variable
Frame rate: 25 fps
Coding: H264
H.264+: off

Stream type: Sub stream
Video type: Video-stream
Resolution: 704x576
Bit rate type: variable
Frame rate: 25 fps
Coding: H264
H.264+: off

Important note:
If you need ONVIF you have to activate this setting (checkbox) and configure a separate ONVIF user for this in the camera web interface under:
network - advanced settings - integration protocol (tab)
activate checkbox: Activate Open Network Video Interface
Create an ONVIF user in the table on the same setting page.