How to wait after closing window before heat is turned on?

[jtulak]

Hi. As far as I understand the window feature, window sensor delay is used for both opening and closing detection. But I would like to have two vastly different values:

• when a window opens, give it 30 sec and then stop
• when a window closes, wait 10 minutes for temperature to stabilize rather than crank up the heat just because the cold air was blowing over the thermometer.

Is there some configuration I'm overlooking? I know I can use a template sensor with delay_on/delay_off options to make the window appear open after it was closed, but that's just a workaround.

[jmcollin78]

Hello, this have been claim many times but this is useless. Just let the VTherm turn on and it will adapts it cycle quickly when temperature goes up.