rate-test-with-fail-condition.mpt

# Set the broker URL
set broker amqp://hostname/test.performance.queue?priority=variable

# Sets the rate to 100 messages per second. This enables "rate-based" testing
set rate 100

# Set the fail condition: fail condition (on) latency. That fails the test if the
# latency is greater than 600ms
set fcl 600

# Use only one parallel instance
set parallel-count 1

# Use a variable message size of 256 bytes
set message-size ~256

# Runs a very short test: 180 seconds
set duration 180s

# Collect peer responses
collect

# Start the receiver
start-receiver
collect

# Start the inspector
start-inspector
collect

# Start the sender
start-sender
collect