Sketch: HTTP (Basic URL trigger)

First run

1. Push any of the buttons. Led indicator will start blinking and new wifi access point will appear for 5 minutes.
2. Connect to the network with phone or PC and open URL 10.10.10.1
3. There you will set your wifi credentials and url address for each button.
   NOTE: https is not implemented as of yet, only http urls will work.
4. (Optional) To further improve performance and battery life, you can add your router's gateway IP address and also pick a static IP for your remote. You will also have to set the static IP on your router.

Changing settings

Push and hold buttons 1 + 4 until the led indicator starts blinking. To shut down Config AP and resume normal function, just push any button.

Battery level

You can use [blvl] shortcode to add battery level to the url. There is an example in config portal.