MissionControl 0.11.0

[ndeadly]

This is the twenty-third official release of Mission Control.

This release adds support for firmware 18.0.0, a new controller, and binary patches allowing Android devices running Joycon-Droid to operate on firmware 12.0.0+ without the need for root access. See below for full changelog.

Note: this release requires atmosphere 1.7.0 or later

New users landing on this release page should first check out the readme on the main project page for the official project documentation. There you can find installation and usage instructions along with an FAQ section that will answer most of your questions.

PS: there is some ongoing testing of preliminary Bluetooth LE and USB support happening in my discord server (see #testing-ble and #testing-usb channels). If you own any of the controllers listed here or any BLE or USB controllers that are not on the list, we'd like to hear from you! (though I don't need any additional input on Xbox and Stadia controllers for now). Please note that these are alpha builds for the purpose of gathering controller information and furthering my understanding of how BLE/USB works on the console. They are NOT intended for general use. There will be bugs and issues. There are no ETAs. I will not be providing any support - if you can't follow the usage instructions, then this is not for you.

Changelog:

• Added full support for firmware 18.0.0.
• Added support for SCUF Vantage 2 controller.
• Added binary patches to enable Joycon-Droid to operate without root access on firmware 12.0.0+.
• Fixed an issue where analog trigger values were swapped for 8BitDo SN30 Pro Xbox Cloud Gaming Edition controller.

---

This discussion was created from the release MissionControl 0.11.0.

[SADEKFCB]

thank you its work perfect with fw 18.0.0

[LordFlaya]

Latest release results in fatal error on 17.0.1 AMS 1.6.2.
Reverting to prior release solves the issue.

[ndeadly]

You need to update atmosphere to version 1.7.0

[luka48]

[ndeadly]

That's not a mission control issue. Something is wrong with your cfw setup

[Leohw5]

My Xbox Series controller still can't connect to the Switch....

[jangsili]

Thanks.

[jangsili]

I tried in Firmware 18 and fresh atmosphere 1.7.0 but it is still not work.
Then I downloaded the last version “MissionControl 0.11.0” and put all files into sdcard.
No good.

[Leohw5]

Looking forward to support Bluetooth LE.

[jangsili]

[ndeadly]

@jangsili this is a legacy firmware version and should work without BLE support. As I said, it's probably a problem with your install. Maybe Mission Control isn't even running. Things you can try:

• Make sure your controller battery level isn't low
• Fix the archive bits on your SD card using hekate
• Delete /config/MissionControl/controllers in case it is corrupted

[Finjii]

After installing the latest update neither of my PS4 controllers can connect to switch, I tried reinstalling MissionControl as well as updating Atmosphere, Hekate and firmware to 18.0. One controller that was already remembered by the console has its LED turn lavender when connected, but no input is registered :(
Any help would be appreciated

[ndeadly]

Sounds like Mission Control might not actually be running. Try fixing the archive bits with hekate

[jangsili]

y fixing the archive bits with hekate

Thanks. It's working now!

[ReyHarkyon]

Could you add the 8bitdo NEO GEO control?