-
Notifications
You must be signed in to change notification settings - Fork 50
NI RFSA Self Calibration Attributes
| Data type |
Access | High Level Functions |
|---|---|---|
| ViInt32 | R/W | None |
Specifies the location in a signal path where an RF downconverter calibration tone is injected or whether the tone is disabled.
Refer to PXIe-5665 Theory of Operation, PXIe-5667 Block Diagram, or PXIe-5668 Block Diagram for more information about signal paths for your device.
Defined and Valid Values:
| Value | Description | Valid For |
|---|---|---|
| NIRFSA_VAL_CAL_TONE_DISABLED (2700) | Disables the calibration tone for the associated signal path. | PXIe-5603/5605/5606 |
| NIRFSA_VAL_CAL_TONE_LOWBAND_RF (2701) | Injects the calibration tone into the low band RF signal path. | PXIe-5603/5605/5606 |
| NIRFSA_VAL_CAL_TONE_HIGHBAND_RF (2702) | Injects the calibration tone into the high band RF signal path. | PXIe-5605/5606 |
| NIRFSA_VAL_CAL_TONE_HIGHBAND_IF (2703) | Injects the calibration tone into the high band IF signal path. | PXIe-5605 |
| NIRFSA_VAL_CAL_TONE_LOWBAND_WITHOUT_ALC (2704) | Injects the calibration tone into the low band RF signal path, bypassing the ALC. | PXIe-5606 |
| NIRFSA_VAL_CAL_TONE_COMB_GENERATOR (2705) | Injects the calibration tone into the high band RF signal path through the Comb Generator. | PXIe-5606 |
| Default Value: NIRFSA_VAL_CAL_TONE_DISABLED |
Supported Devices: PXIe-5603/5605/5606 (external digitizer mode), PXIe-5665/5667/5668
| Data type |
Access | High Level Functions |
|---|---|---|
| ViReal64 | R/W | None |
Specifies the frequency of the RF downconverter calibration tone, in hertz (Hz).
Valid Values
PXIe-5603/5605—134 MHz to 13.2 GHz
PXIe-5606—34.5 MHz to 4 GHz
Default Value: 612.5 MHz
Supported Devices: PXIe-5603/5605/5606 (external digitizer mode), PXIe-5665/5667/5668
| Data type |
Access | High Level Functions |
|---|---|---|
| ViReal64 | R/W | None |
Specifies the internal gain self-calibration correction for the IF filter through path. The value you specify using this attribute overrides any previously-set value.
Units: dB
Default Value: 0
Supported Devices: PXIe-5603/5605
| Data type |
Access | High Level Functions |
|---|---|---|
| ViReal64 | R/W | None |
Specifies the internal gain self-calibration correction for the 300 kHz IF filter path. The value you specify using this attribute overrides any previously-set value.
Units: dB
Default Value: 0
Supported Devices: PXIe-5603/5605/5606
| Data type |
Access | High Level Functions |
|---|---|---|
| ViReal64 | R/W | None |
Specifies the internal gain self-calibration correction for the 5 MHz IF filter path. The value you specify using this attribute overrides any previously-set value.
Units: dB
Default Value: 0
Supported Devices: PXIe-5603/5605/5606
| Data type |
Access | High Level Functions |
|---|---|---|
| ViReal64 | R/W | None |
Specifies the internal gain self-calibration correction for the 100 MHz IF filter path. The value you specify using this attribute overrides any previously-set value.
Units: dB
Default Value: 0
Supported Devices: PXIe-5606
| Data type |
Access | High Level Functions |
|---|---|---|
| ViReal64 | R/W | None |
Specifies the internal gain self-calibration correction for the 320 MHz IF filter path. The value you specify using this attribute overrides any previously-set value.
Units: dB
Default Value: 0
Supported Devices: PXIe-5606
| Data type |
Access | High Level Functions |
|---|---|---|
| ViReal64 | R/W | None |
Specifies the internal gain self-calibration correction for the 765 MHz IF filter path. The value you specify using this attribute overrides any previously-set value.
Units: dB
Default Value: 0
Supported Devices: PXIe-5606
| Data type |
Access | High Level Functions |
|---|---|---|
| ViInt32 | R/W | None |
Specifies the location in a signal path where an RF conditioning calibration tone is injected or whether the tone is disabled.
Defined Values:
| NIRFSA_VAL_CAL_TONE_DISABLED (2700) | Disables the calibration tone for the associated signal path. |
|---|---|
| NIRFSA_VAL_CAL_TONE_LOWBAND_RF (2701) | Injects the calibration tone into the low band RF signal path. |
| NIRFSA_VAL_CAL_TONE_HIGHBAND_RF (2702) | Injects the calibration tone into the high band RF signal path. |
| Default Value: NIRFSA_VAL_CAL_TONE_DISABLED |
Supported Devices: PXIe-5667, PXIe-5693/5698
| Data type |
Access | High Level Functions |
|---|---|---|
| ViReal64 | R/W | None |
Specifies the frequency of the RF conditioning calibration tone, in hertz (Hz).
Valid Values: 34.5 MHz to 7.5 GHz
Default Value: 1.0 GHz
Supported Devices: PXIe-5667, PXIe-5693/5698
Creating and Setting Up a gRPC Server
Session Utilities API Reference
gRPC API Differences From C API
Sharing Driver Sessions Between Clients
C API Docs
NI-DAQmx
- gRPC API Differences From C API
- Task Configuration And Control
- Channel Configuration And Creation
- Timing
- Triggering
- Read Functions
- Write Functions
- Export Hardware Signals
- Scale Configuration
- Internal Buffer Configuration
- Advanced Functions
- System Configuration
- Error Handling
- Buffer Attributes
- Calibration Info Attributes
- Channel Attributes
- Device Attributes
- Export Signal Attributes
- Persisted Channel Attributes
- Persisted Scale Attributes
- Persisted Task Attributes
- Physical Channel Attributes
- Read Attributes
- Scale Attributes
- System Attributes
- Task Attributes
- Timing Attributes
- Trigger Attributes
- Watchdog Attributes
- Write Attributes
NI-DCPOWER
- Setup Functions
- Configure Functions
- Measurement Functions
- Control Functions
- Trigger And Event
- Attribute Functions
- Query Functions
- Calibration Functions
- Utility Functions
- Supported Device
- Source Attributes
- Transient Attributes
- Voltage Attributes
- Current Attributes
- Pulse Voltage Attributes
- Pulse Current Attributes
- Cutoff Attributes
- Measurement Attributes
- Trigger Attributes Functions
- Event Attributes
- Advanced Attributes
- Inherent Ivi Attributes
- Supported Device Attributes
NI-DIGITAL PATTERN DRIVER
- Init And Close Functions
- Session Locking Functions
- Utility Functions
- Error Handling Functions
- Calibration Functions
- Attributes Functions
- Pin Map Functions
- Low Level Functions
- Low Level Action Functions
- Pin Control Functions
- Static IO Functions
- Clock Generator Functions
- Levels And Timing Functions
- TDR Functions
- PPMU Configuration Functions
- DC Voltage Functions
- DC Current Functions
- PPMU Action Functions
- Pattern Configuration Functions
- Pattern Action Functions
- History Ram Functions
- Source Memory Functions
- Capture Memory Functions
- Triggers And Events Functions
- Conditional Jump Trigger Functions
- Sequencer Flag Functions
- Sequencer Register Functions
- Match Fail Combination Functions
- Pattern Results Functions
- Sort Results Functions
- Frequency Measurement Functions
- IVI Inherent Attributes
- Specific Driver Information Attributes, Read Only
- Driver Setup Information Attributes
- Device Attributes
- Pin Control Attributes
- Level Configuration Attributes
- Trigger Configuration Attributes
- PPMU Attributes
- Patterns Attributes
- Pattern Opcode Event Attributes
- Timing Offset Attributes
- Keep Alive Attributes
- Frequency Measurement Attributes
- Clock Generator Attributes
- History RAM
- Synchronization Attributes
- TDR Endpoint Termination Attributes
NI-FGEN
- Setup Functions
- Configuration Functions
- Standard Output Functions
- Arbitrary Waveform Output Functions
- Arbitrary Sequence Output Functions
- Incremental Waveform Write Functions
- Configure Clock Functions
- Trigger And Syncronizations Functions
- 5404 Routing Functions
- Script Output Functions
- Configure Onboard Signal Processing Functions
- Configure Peer To Peer Functions
- Attribute Functions
- Waveform Control Functions
- Error Functions
- Output Attributes
- Arbitrary Waveform Attributes
- Data Transfer Attributes
- Onboard Signal Processing Attributes
- Peer To Peer Attributes
- Standard Function Attributes
- Clock Attributes
- Event Attributes
- Triggering Attributes
- Instrument Specific Attributes
- Inherent IVI Attributes
- 5401 5411 5431
NI-RFmx Bluetooth
- gRPC API Differences From C API
- General Functions
- Configuration Functions
- Set And Get Attribute Functions
- Fetch Results Functions
- Utility Functions
- Build String Functions
- Advanced Functions
- General Attributes
- Trigger Attributes
- Packet Attributes
- Auto Detect Signal Attributes
- Modacc Attributes
- ACP Attributes
- Twenty dB Attributes
- Frequency Range Attributes
- TXP Attributes
- Advanced Attributes
NI-RFmx NR
- gRPC API Differences From C API
- General Functions
- Configuration Functions
- Set And Get Attributes Functions
- Fetch Results Functions
- Utility Functions
- Build String Functions
- Advanced Functions
- General Attributes
- Trigger Attributes
- Signal Detection Attributes
- Component Carrier Attributes
- List Attributes
- Modacc Attributes
- ACP Attributes
- CHP Attributes
- OBW Attributes
- SEM Attributes
- TXP Attributes
- Pvt Attributes
- Advanced Attributes
NI-RFmx LTE
- gRPC API Differences From C API
- General Functions
- Configuration Functions
- Ch Configuration Functions
- NB IoT Configuration Functions
- ModAcc Configuration Functions
- ACP Configuration Functions
- CHP Configuration Functions
- OBW Configuration Functions
- SEM Configuration Functions
- PVT Configuration Functions
- SlotPhase Configuration Functions
- SlotPower Configuration Functions
- Set And Get Attribute Functions
- ModAcc Fetch Functions
- ACP Fetch Functions
- CHP Fetch Functions
- OBW Fetch Functions
- SEM Fetch Functions
- PVT Fetch Functions
- SlotPhase Fetch Functions
- SlotPower Fetch Functions
- Utility Functions
- Build String Functions
- Advanced Functions
- General Attributes
- Trigger Attributes
- Component Carrier Attributes
- ModAcc Attributes
- ACP Attributes
- CHP Attributes
- OBW Attributes
- SEM Attributes
- PVT Attributes
- SlotPhase Attributes
- SlotPower Attributes
- Advanced Attributes
NI-RFmx SpecAn
- gRPC API Differences From C API
- General Functions
- Configuration Functions
- Set And Get Attribute Functions
- Read Functions
- Fetch Functions
- Utility Functions
- Marker Functions
- Build String Functions
- Advanced Functions
- General Attributes
- Trigger Attributes
- ACP Attributes
- Cdf Attributes
- CHP Attributes
- Fcnt Attributes
- Harm Attributes
- OBW Attributes
- SEM Attributes
- Spectrum Attributes
- Spur Attributes
- TXP Attributes
- AMPM Attributes
- Dpd Attributes
- IQ Attributes
- IM Attributes
- NF Attributes
- Phasenoise Attributes
- PAVT Attributes
- Advanced Attributes
NI-RFmx WLAN
- gRPC API Differences From C API
- General Functions
- Configuration Functions
- Set And Get Attribute Functions
- Fetch DSSS ModAcc Functions
- Fetch OFDM ModAcc Functions
- Fetch SEM Functions
- Fetch TXP Functions
- Fetch PowerRamp Functions
- Utility Functions
- Build String Functions
- Advanced Functions
- General Attributes
- Trigger Attributes
- OFDM Attributes
- Auto Detect Signal Attributes
- DSSS ModAcc Attributes
- OFDM ModAcc Attributes
- SEM Attributes
- TXP Attributes
- PowerRamp Attributes
- Advanced Attributes
NI-RFSA
- General Functions
- Configuration Functions
- Acquisition Functions
- Utility Functions
- Calibration Functions
- General Attributes
- Vertical Attributes
- Signal Path Attributes
- Acquisition Attributes
- Acquisition Attributes
- Triggers Attributes
- Events Attributes
- Device Characteristics Attributes
- Peer To Peer Streaming Attributes
- Configuration List Attributes
- Inherent IVI Properties Attributes
- De-embedding Attributes
- Self Calibration Attributes
- Factory Calibration Attributes
- External Alignment Attributes
- Device Specific Attributes
NI-RFSG
- General Functions
- Generation Configuration
- Utility Functions
- Calibration Functions
- Arb Attributes
- Clock Attributes
- Configuration List Attributes
- De-embedding Attributes
- Device Characteristics Attributes
- Device Specific Attributes
- Events Attributes
- External Calibration Attributes
- Inherent IVI Attributes Attributes
- IQ Impairment Attributes
- Load Configurations Attributes
- Modulation Attributes
- Obsolete Attributes
- Peer To Peer Attributes
- RF Attributes
- Self Calibration Attributes
- Triggers Attributes
NI-SCOPE
- Setup Functions
- Configure Functions
- Attribute Functions
- Acquisition Functions
- Measurement Functions
- Calibrate Functions
- Utility Funcitons
- Error Handling Functions
- IVI Compliance Or Obsolete Functions
- Vertical Attributes
- Horizontal Attributes
- Trigger Attributes
- Clocking Attributes
- Synchronization Attributes
- Acquisition Attributes
- Waveform Measurements Attributes
- Onboard Signal Processing Attributes
- Peer To Peer Streaming Attributes
- Device Attributes
- IVI Or Obsolete Attributes
- Instrument Capabilities Attributes
- If Digitizer Attributes
NI-XNET
- gRPC API differences from C APIs
- General Functions
- Cluster Properties
- Database Properties
- Device Properties
- ECU Properties
- Frame Properties
- Interface Properties
- LIN Schedule Entry Properties
- LIN Schedule Properties
- PDU Properties
- Session Ethernet Properties
- Session Frame Properties
- Session Interface Properties
- Session Properties
- Session SAE J1939 Properties
- Signal Properties
- Subframe Properties
- System Properties
- IP-Stack Functions
- Socket Options
- Socket Functions