Change Sigfox settings of the Wisol WSSFM10R2 module in your XKit development kit to RCZ2
- Separate the shield from the main board
- Upload this sketch to your Arduino Uno board
- Put the shield back in place within 10 seconds (or reset the board once the shield is there)
Sigfox is using slightly different radio configurations depending on the local regulations & available spectrum.
Please check the Sigfox Developer Portal for more details.
The RCZ2 has the following properties :
- 902 MHz Uplink central frequency
- 22 dBm / 100mW power output
It's used in the following countries (as of April 17) :
- 🇧🇷 Brazil
- 🇲🇽 Mexico
- 🇺🇸 USA