esphome firmware for esp32_8ch_motor_shield
#install esphome
pip install --upgrade esphome
#Preparation
- Check the wiki
- Adapt config.yaml to your needs
- Adapt sensor_temperature.yaml with your temperature sensors
- Adapt wifi.yaml + secrets.yaml
#1st time upload :
- Detach the ESP32 board from the shield and connect it the through usb
- for flashing : press boot button for 2-3 seconds before the serial connection initialize
- After OTA update, the EN (reset) button must be pressed to run firmware
- do not use gpio12 (MTDI)
- the future binary upload will go trough OTA wireless
#compile to check for errors
esphome compile config.yaml
#compile & upload
esphome run config.yaml