Generate display patterns for laser galvanometer, using ESP8266. Speed of the pattern is limited by the galvanometers, usually 20,000 - 30,000 positions per second. A pattern with more than a few thousand positions will flicker. Large patterns, e.g. LouisWainCat @ 20,000 positions, require a long exposure (one second or more) to view. Reducing the speed of the data sent to the galvanometer produces a more accurate pattern, but with more flicker.
Based on "Arduino Laser Show With Real Galvos" by DeltaFlo:
http://www.instructables.com/id/Arduino-Laser-Show-With-Real-Galvos/
- Adafruit HUZZAH ESP8266 (https://www.adafruit.com/product/2821)
- Laser Galvonometer (e.g.: https://www.ebay.com/itm/20Kpps-max-30kpps-laser-scanning-galvo-scanner-ILDA-Closed-Loop-for-laser-show-/302624823271)
- TTL Laser Diode (https://www.adafruit.com/product/1056)
- Fixed Laser Mounting Stand (https://www.adafruit.com/product/1094)
- Dual Channel 12-bit DAC (MCP4822 or MCP4922. see: http://www.instructables.com/id/Arduino-Laser-Show-With-Real-Galvos/ for details)
- Bipolar Amplifier (see: http://www.instructables.com/id/Arduino-Laser-Show-With-Real-Galvos/ for details)
(M4-.70 screws)
The first time it boots it will create a Soft Access Point with SSID: LaserDemo and PSK: carbondioxide.
Open http://laserdemo.local/config to configure the WiFi
http://laserdemo.local/ allows you to select objects for display:
- The Object and Generator lists are generated dynamically from the contents of the objName and genName arrays.
- KPPS is the speed of the scanner, Kilo Positions Per Second
- LTD Laser Toggle Delay, the latency of the scanner, in microseconds
- LQ Laser Quality, maximum line segment length
It is impossible to scan both fast and wide.
When the amplifier gain matches the scan rate, the middle circle will fit inside the the middle square, just touching the sides:
I got good results with 15 degrees deflection @ 20 KPPS (9.5" wide at 36").
Typical generic galvonometer specs:
Convert the ILD file to text using LaserBoy http://laserboy.org/code/LaserBoy_2017_08_06.zip:
- i input
- 1 ILD
- filename
- 1 replace
- o output
- 4 text
- 3 all frames
- filename
LaserBoy has options for optimizing the output (e.g.: h - shiftS) which might also be useful.
Convert the text file to an include file (.h):
Scripts/convert.pl ilda12k.txt
void setup()
{
// initialize object array
#include "ilda12k.h"
#include "barney10.h"
...
It's also possible to drive the galvonomters directly with an audio signal, bypassing the ESP8266.
For that you need a cable and an audio interface modified for DC-coupling:
Several laser programs can generate the audio (even LaserBoy), or use a DSP program like Gnuradio-Companion or Linux Laptop Orchestra (Pd-L2Ork/Purr-data):
