- prep both DustTrak II units w/ PM2.5 & PM10 inlets
- verify Kestrel weather meter working OK, print user manual
CO2 (tracer) point-source release equipment
-
pure CO2 tanksordered (4) 50# tanks -
regulatororder one new, other from IAQ-
test for regulator freeze-updoes frost over but direct sunlight is sufficient to prevent freezing; tested up to full range 20+50 SLPM - install heat tape on new regulator
-
-
digital flowmeterone 50SLPM from 415, other 20LPM from IAQ -
DustTrak II w/ PM2.5 inletunit #1 (s/n 8530150710)-
verify logger program has correct det. scaling from IAQ study
-
-
Licor LI-840A CO2/H2O analyzer + pump *unit #2 (s/n HGA-2573)-
validate analog voltage scaling range -
add backup analog measurement CO2 only
-
-
GPS units/n 1A4171474-
verify programmed for use with CR1000
-
- Campbellsci datalogger s/n 50905
-
check for latest firmware32.02 -
replace lithium battery (is below 3V) - finish program
-
- extension cord & power strip
-
small Honda generatorbought Honda EU2200 generator-
test operationran for several hours on PETB roof on 3/4 tank
-
Probably an open-bed pick-up.. except motor pool only has those in towing size.
-
DustTrak II w/ PM2.5 inletunit #2 (s/n 8530152108)-
verify logger program has correct det. scaling from IAQ study -
needs internal battery back from unit #1
-
-
Licor LI-840A CO2/H2O analyzer + pumpunit #1 (s/n HGA-1666)-
validate analog voltage scaling rangeset to 0-2500ppm/0-5V -
add backup analog measurement CO2 only
-
-
Airmar unit for WX+GPS150WX from IAQ-
verify NMEA sentence config
-
-
Campbellsci dataloggers/n 67138-
check for latest firmware32.02 - finish program
-
-
cigarette-lighter inverterblack 400W unit-
verify operates OK on internal DC socket
-
-
road worthy enclosure that sufficiently elevates inlets and is securable to vehicle