Skip to content

Latest commit

 

History

History
47 lines (32 loc) · 3.6 KB

README.md

File metadata and controls

47 lines (32 loc) · 3.6 KB
Raw

CVTnithm

CVTnithm is a cable adapter in PCB form. That's about it!

Thanks to @48productions who made a guide on how to make all the necessary wiring and made me realize:

  • Digikey doesn't sell the crimpable version of the connector
  • I'm not buying a single part from JST directly
  • also i don't want to buy a specialty crimper for molex pins (except i kinda had to for handling ac power lmao)
  • also i'm lazy, but not lazy enough to make a pcb

I'm sorry I didn't have a creative name for this project

To build this, you will need the following components:

Connecting this board internally requires the following:

  • (3) 2x5 IDC cables, such as these on Amazon. The cables should be a straight connection without any twists or other modification.

Solder each of these connectors in their respective places; each connector has a unique footprint so it should be fairly obvious what connectors need to go where. Be mindful of orientation!

So I soldered this, now what?

  • Open up your ALLS and locate the bundle of unused cables. Undo this bundle and find the unused cable containing two PC 4-pin power connectors and a floppy drive connector.
    • This is the cable we'll be using to supply power; there should be just enough length for this cable to reach.
  • Remove the serial brackets by undoing the two PCI bracket screws, unplugging them from the motherboard in the process.
  • Note the COM_ number on each of the serial ports on the motherboard. Plug one IDC cable into each of the serial ports. Plug the other end into the CVTnithm PCB into its respective COM_ port.
  • Plug in the two PC 4-pin power connectors.

What about mounting?

Print the two 3MF files included in this repository in the orientations provided. The bottom bracket requires support material, and it's recommended to disable support for bridges as a small tool (like a dental pick) will be needed to clean out some of the support material otherwise. If you cannot disable support for bridges (due to slicer or printer limitations), you may try printing with the part upside-down as this will allow you to more easily clean out the support material.

With the rear of the ALLS facing you (herein described as the "front"), install everything as follows:

  • Insert the bottom bracket into the two empty PCI slots from the front. The flat side should be facing you, with the U shape upward.
  • Slide the bottom bracket as far down as you can. The metal of the PCI bracket should slide into a notch in the print.
  • Looking at the ALLS from the top, fit the CVTnithm PCB into the notch in the bottom bracket. The CVTnithm board will be installed inside the ALLS, with the IDC connectors facing downward.
  • Place the top bracket over the CVTnithm PCB so the flat side is facing you, with the screw hole towards you. Reinstall the two PCI screws, making sure the CVTnithm PCB is retained by the bracket.