Skip to content

OLED Add On Setup Info

Jump to bottom Edit New page
TABYDACAT edited this page Jun 11, 2021 · 4 revisions

NOTE: This OLED Add-On is completely optional to GBS-Control. If you choose not to install it, your GBS-Control board will still operate normally.

This addon is not meant to replace the Web UI and was/is just a means to help select the more common settings. This is still a work-in-progress to add more features in the future.

Installation:

  • Materials Needed:

    • 1x I2C 0.96" OLED Screen
    • 1x Rotary Encoder (EC11)
    • 2x 0.47uF Capacitors (50V, Electrolytic)

  • Schematic:

NOTE: This is just a general/draft "how-to" schematic.

schematic_test1

General Usage

After the boot logo splash screen, you'll be presented with a simple menu system.

mainMenu

By rotating left or right on the encoder, the indicator will move up or down. Pressing the encoder will select the option. (If the indicator is acting odd, you may have the CLK and DATA pins of the encoder reversed)

Each submenu will have a BACK option which upon selecting will go back to the main menu, for example:

resolutionBackEx

The only menu that this is slightly different is the Current Settings menu. Within this menu you will be able see various specs that are currently being utilized. While in this menu press the encoder once without rotation and this will bring you back to the main menu.

currentsettingsExample

Additional Information

OLED:

  • Communication method is very important for this! Please, try to get a hold of an I2C not a SPI screen.
  • At the moment, this was designed (font/text alignments) for the 0.96" variant of screens. Any other size will produce "interesting" results.
  • Color configurations will be found in various listings/datasheets for screens (BLUE,BLUE/YELLOW,WHITE). While any color configuration will work, it's recommended to stick to a single color option to achieve a cleaner look. Case in point shown below.

dcbootExample

Rotary Encoders:

  • This type of encoder has many applications and benefits to its design. However, one major downside is that it tends to be a noisy device. Along with the ISR and filter the goal is to not have many wrong inputs occur while rotation or selection.
  • Any general EC11 model of encoder will work. Pretty much "EC11 Rotary Encoder" on Amazon/Ebay will yield the correct results. It's a fairly inexpensive and common part
  • Breakout board versions of this part should work, but isn't entirely recommended. Mainly coming down to cost and the fact that there could be many variations of said breakout boards out there. Meaning, potentially differing resistor/capacitor values for the filtering circuit. This could lead to disruption of the ISR. Tests were done to ensure the capacitors/resistors worked well together with the ISR. If you choose to use a breakout then omit the capacitors and pull-up resistors.
Add a custom footer
Add a custom sidebar
Clone this wiki locally