VHDL Source: olo_base_cc_n2xn
This component implements a clock crossing with AXI-S handshaking for transferring data from one clock domain to another one that runs at an integer multiple of the frequency of the input clock frequency. It can for example be used to transfer data from a 50 MHz clock domain to a 100 MHz clock domain (both generated by the same PLL).
Note that the two clocks must be phase aligned.
Note that the clock crossing does not work if the two clocks have the same frequency.
This block follows the general clock-crossing principles. Read through them for more information.
| Name | Type | Default | Description |
|---|---|---|---|
| Width_g | positive | - | Data width in bits. |
| Name | In/Out | Length | Default | Description |
|---|---|---|---|---|
| In_Clk | in | 1 | - | Input clock |
| In_RstIn | in | 1 | '0' | Reset input (high-active, synchronous to In_Clk) |
| In_RstOut | out | 1 | N/A | Reset output (see clock-crossing principles, synchronous to In_Clk) |
| In_Data | in | Width_g | - | Input data |
| In_Valid | in | 1 | '1' | AXI4-Stream handshaking signal for In_Data |
| In_Ready | out | 1 | N/A | AXI4-Stream handshaking signal for In_Data |
| Name | In/Out | Length | Default | Description |
|---|---|---|---|---|
| Out_Clk | in | 1 | - | Output clock (must run at an integer multiple of In_Clk) |
| Out_RstIn | in | 1 | '0' | Reset input (high-active, synchronous to Out_Clk) |
| Out_RstOut | out | 1 | N/A | Reset output (see clock-crossing principles, synchronous to Out_Clk) |
| Out_Data | out | Width_g | N/A | Output data |
| Out_Valid | out | 1 | N/A | AXI4-Stream handshaking signal for Out_Data |
| Out_Ready | in | 1 | '1' | AXI4-Stream handshaking signal for Out_Data |
The architecture of the entity is simple, not detailed description is required.