You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I didn't see any information on the case you used. Is it possible to share the source of your watch case, or give some tips on how to find a suitable case?
Thanks,
The text was updated successfully, but these errors were encountered:
Hi, thank's. I use case from old China wristwatch.
I still don't know how to do 3D modeling, so I didn't design the case, but used an already ready one.
Yes, I am open to all advice from your side
...or give some tips on how to find a suitable case?
PCB have size 35 mm in the diameter, search for cases from an old watch where the dial is 35 mm in diameter
The thickness of the PCB is recommended to take 0.8mm, because it will be very tight in the case with the battery.
Hi, cool project, found it on hackaday.
I didn't see any information on the case you used. Is it possible to share the source of your watch case, or give some tips on how to find a suitable case?
Thanks,
The text was updated successfully, but these errors were encountered: