This is the LightMotion Firmware for the Arduino/MX3 Platform.
Version: 0.07
You must install the following libraries to compile the MotionEngine:
For more information on installing libraries in Arduino, see Arduino Libraries Guide.
You must use at least Arduino version 1.5.2 (nightly build is recommended), and must use the Dynamic Perception AT90USB Core for Arduino. This can be downloaded here
Key tips for uploading to the MX3:
- Ensure you select 'AT90USB128x 16Mhz' as the Board Type (do not select the 'USB Serial' variant!)
- You must press and hold the [Enter] key before plugging in the USB port on the MX3
- Note that the LCD backlight will flash showing it is ready for firmware upload
Use the LUFA CDC bootloader from the ArduinoAT90USB repo.
More information can be found at http://www.dynamicperception.com/
(c) 2008-2013 C.A. Church / Dynamic Perception LLC
The LightMotion firmware is distributed under a GPLv3 License. See LICENSE.txt for licensing information.