the ES5506 instrument editor contains three tabs: Sample, ES5506 and Macros.
for sample settings, see the Sample instrument editor.
ES5506 contains a filter, which is somewhat configurable. there's also a hardware envelope, but it's probably most useful for smoothing.
you may use this tab to set up ES5506-specific parameters:
- Filter Mode: sets filter mode.
- HP/K2, HP/K2: run high-pass twice using filter K2.
- HP/K2, LP/K1: run high-pass using filter K2, and then low-pass using filter K1.
- LP/K2, LP/K2: run low-pass twice using filter K2.
- LP/K2, LP/K1: run low-pass using filter K2, and then again using filter K1.
- Filter K1: set coefficient 1 (K1). effectively controls cutoff.
- Filter K2: set coefficient 2 (K2). effectively controls cutoff.
- Envelope count: set length of hardware envelope (it's very short even at highest value).
- Left Volume Ramp: how much to change left volume on every envelope step.
- Right Volume Ramp: how much to change right volume on every envelope step.
- Filter K1 Ramp: how much to change filter K1 every envelope step.
- Filter K2 Ramp: how much to change filter K2 on every envelope step.
- K1 Ramp Slowdown: increases length of K1 ramp.
- K2 Ramp Slowdown: increases length of K2 ramp.
- Volume: volume sequence.
- Arpeggio: pitch sequence.
- Filter Mode: sets filter mode.
- Panning (left): output level for left channel.
- Panning (right): output level for right channel.
- Pitch: fine pitch.
- Phase Reset: trigger restart of waveform.
- Filter K1: K1 sequence.
- Filter K2: K2 sequence.
- Outputs: ES5506 has 6 stereo output (total 12). select which pair of outputs to use.
- Control: reverse/pause sequence.