esp32-s3 supported ?

[Wek-mad]

can it work with esp32-s3 ? I'm can't find any s2 in my town. tks

[tobozo]

ESP32-S3 is not the device intended for this project but since it meets all the hardware requirements it could probably work, make sure you're using the latest branch

[Wek-mad]

thanks, i will try comeback with the result.

[Wek-mad]

i tested it with the S3 but when i try to access the webpage it just a blank white page, any idea or fix ?

[tobozo]

any idea or fix

I have a LoLin S3Pro to test with eventually, but I can reach the WebUI all right and I have no idea what to do to reproduce your blank page, so I'll need more hardware details on your build, a list of the modifications you made to the code to get it working, and a capture of your menu options (here's mine:).

[Wek-mad]

this is my board (ESP32-S3-WROOM-1-N16R8)

this is my menu, I actually not change anything to make the code working.
If you need anything else can i have your discord or something?
I would really want to use your code for my cybersecurity class.

[tobozo]

I actually not change anything to make the code working.

then you didn't use the latest branch as it wouldn't let you compile on esp32s3

use the arduino-esp32-2.0.3-RC1 branch, then just comment out whatever line the compiler complains about and you should be good to go.

this is my board (ESP32-S3-WROOM-1-N16R8)

oh you're using a bare module ? I'm not sure about the behaviour of the app without a SD card reader though.

Also LittleFS doesn't cope well with USBMSC and can get corrupted, so if you're not planning to add a SD Card reader, be prepared to use the ESP32 Sketch Data Upload utility a lot!

The positive side: with your bare module you can probably listen to both uart and usb jtag, and set the Core Debug Level to debug to see what happens under the hood.

Also if you don't have installed this tool yet, I strongly recommend you do.

I would really want to use your code for my cybersecurity class.

contributions to this project are welcome !

[Wek-mad]

I'm using the newest branch and it said This project is for ESP32-S2 only.
I remove the config_check.h and it compile smoothly without any error
The AP it up and running but when access the WebUI by typing 192.168.4.1 it just a blank page without anything.
I might adding a sd card module later this week or next week, It might solve the problem