Electronic Modules

A few libs, including a lot of Commodore / CSG parts

This project is about designing a 1.5 bit stage Pipeline ADC & the OpAmp required for its MDAC.

Schematic, Layout Design & Simulation in 180nm Technology

Low cost, low part count CH32V003-based oscilloscope

1/2 channel 4-20 mA to voltage converter boards using LMP8640 current sense monitor.

《电子系统设计-基础和测量系统篇》理论计算用Mathematica代码

A simple yet powerful dummy/electronic load, with minimum component requirements and a lot use cases.

Headphone Amplifier project featuring the NE5532 OP-Amp and a powerful Class AB output stage

Learn to design and build an 4 channel LM35 temperature sensor chip Signal conditioner amplifier circuit based on the popular opamp LM324 using Kicad 6.0.The board can be used to monitor temperature from 4 different sources at the same time and can be used for building your own data acquisition system.

Standalone "interposition-transparent" multichannel DI/splitter/recorder unit

voltage and current regulated power supply

TA Ship work and Various other Projects done using LTSpice for the fulfilment of Analog Electronics Course at BITS Pilani.

Analog Circuit design using ABC algorithm

A folded-cascode OTA with 3.3V power supply and 54.27 dB DC gain with 66.8MHz unity frequency

A 2 stage CMOS OTA with Differential amplifier with active load as the first stage followed by Common Source stage using Cadence

This MCC based MPLAB X IDE example shows how to interface an electret microphone with a microcontroller (MCU) using the Analog Signal Conditioning (OPAMP). In addition to the microphone, only one resistor and one capacitor are required.

Accurate and high-current analog function generator

This MCC based MPLAB X example shows how to calibrate the gain and offset of the OPAMP when configured as a Programmable Gain Amplifier (PGA). The internal DAC and ADC are used to perform the calibration procedure. No external components are required.