Adding hotswap sockets

[andrwui]

Hi!

Would it be possible to add hotswap sockets to the build without using a pcb?
I'm asking because I like to change switches every now and then, and as the build isn't planed with hotswap sockets in mind, they may not fit in the casing.

Thank you for the amazing design!

[victorlucachi]

hey, thank you for the kind words.

you could adapt the switch plates to fit hotswap sockets, but it might be just a little bit too tight; there's almost no room to spare towards the front of the case, under the thumb cluster, and above the controller as well.