General:
sudo apt install git build-essential
For u-boot build:
sudo apt install gcc-arm-linux-gnueabihf \
bison flex swig python3-distutils python3-dev
For Linux Kernel 5.12:
sudo apt install libssl-dev u-boot-tools libmpc-dev
For generating Debian rootfs:
sudo apt install multistrap qemu-user-static
-- Also (Don't remember where):
sudo apt install python
Run:
./auto-create-image.sh
Copy image to SD card (Replace /dev/sdX with your SD card):
sudo dd bs=4M if=licheepi-debian.img of=/dev/sdX conv=fsync
The USB OTG port is configured to emulate a ethernet device when connected to a computer
The IP is configured as: 192.168.11.2
To communicate with the board you need to set the new ethernet port with 192.168.11.1 and gateway being 192.168.11.1 and DNS 8.8.8.8
You should be able to connect using SSH now:
ssh root@192.168.11.1
When asked for password, just press ENTER.
add default gateway with:
route add default gw 192.168.7.1
Now, on your PC:
Share internet with the following:
sudo iptables --table nat --append POSTROUTING --out-interface wlp3s0 -j MASQUERADE
sudo iptables --append FORWARD --in-interface wlp3s0 -j ACCEPT
echo 1 | sudo tee -a /proc/sys/net/ipv4/ip_forward
where wlp3s0 is your network card connected to the internet.
Set date with:
timedatectl set-date "YYYY-MM-DD HH:MM:SS"
Enable swap:
swapon /dev/mmcblk0p2