Add/remove associations not possible on the Heatit z-trm2 TF021 thermostat

[nesheimt]

Checklist

• I have read and followed the above instructions

• I have checked the troubleshooting section and my problem is not described there.

• I have read the changelog and my problem was not mentioned there or the fix did not work.

Describe the issue

What is happening?

1. I'm not able to add or remove associations
2. Relay state is not updated
3. Temperature reports are only comming every 9 hours (and I have set reg 17 to 6, which is report every minute)

What did you expect to happen instead?
I'd expect to add/remove associations and the relay state and temperature updates.

Steps to reproduce the behavior:
I'm mainly using the zwave js ui front end to change associations, and look for updates in relay state and temperature. The result is identical if I use the Homeseer menu funcions, no difference that is.

Anything else we should know?
The TF021 has updated firmware v1.92 I can do assiciations setuop on other devices without any problems. I see that there are similar open/on-hold discussions/issues but they have no activity, but was asked by AlCalzone to threate this discussion. Main problem, associaitons, are not listed anywhere.
I think that root cause of my issues are problems with associations and if solved relay state and temperature reports might be fine. I can also ask the manufacturer helpdesk for information if required(I saw this was required in another issue), but the I need detailed instructions.

HeatIt_1v9.pdf

Software versions

zwave-js-ui: 9.20.0
zwave-js: 13.3.1
home id: 3699079014
home hex: 0xdc7b7766

I'm using Homeseer4 v4.2.21.0 system, with the Z-wave plus 1.0.2.0 plug-in.

Z-Wave Controller (Stick/Dongle/...)

Homeseer Smartstick G8

Device information

Manufacturer: Heatit 0x019b
Model name: TF021 Thermostat 0x0003-0x0201
Node ID: 42

Checklist

• I made sure to provide a driver log on level debug.

• The log includes a re-interview of the problematic device (if applicable).

• The log includes the problematic interaction with the device (if applicable).

• I provided the node ID of the problematic device (if applicable).

Upload Logfile

The logfiles contain a Re-interview and trying to remove Group 2 and 3

zwave-js-ui-store (1).zip
node_42_dump (1).json
node_42 (1).json
nodes_dump.json

[nesheimt]

Hi @AlCalzone
Does this post contain sufficient with information to start an investigation?

[nesheimt]

Official Heatit documentation/configuration of the TRM2 v1.92 device is here(Homey app):
https://github.com/Heatit-Controls/no.thermofloor/tree/main/drivers/TF_Thermostat_FW1.92
In Homey the v1.92 is listed as a separate device even though it shares the same HW as https://github.com/Heatit-Controls/no.thermofloor/tree/main/drivers/TF_Thermostat (which is the devices with FW lower that v1.92)

Another source for v1.92 information is:
https://github.com/OpenZWave/open-zwave/blob/master/config/thermofloor/heatit021-v1.92.xml

[AlCalzone]

Looks like the Supervision implementation on that device is buggy. When trying to do things on endpoints with Supervision, the device responds from the root device instead.

[AlCalzone]

Escalated to an issue: #7320